When people are feeling ambitious, they may attempt a do it yourself appliance repair project they would normally leave to the experts. Sometimes, appliance repair projects are best left to the oven or refrigerator repair Pittsburgh, but those looking to save a buck or gain some experience can try appliance repair, do it yourself style. An appliance that almost every kitchen has is a range.
Appliance repair instruction manuals and videos can be found online claiming to teach appliance repair. For an oven in need of appliance repair, there are some basic steps. To replace an oven, there are eleven steps for the appliance repair at hand.
Step one: Install the anti-tip bracket. Not every stove has one, but if it does it needs to be secured to the floor. The anti-tip bracket should be pressed against the back wall so the range can slip in. The left rear leveling leg goes into the anti-tip bracket.
Step two: Remove the oven door. Disengaging the spring-loaded hinge catches after the door is removed can lead to injury. Also, it is not recommended to lift or carry the door by the handle. With the door fully opened, the catch needs to be rotated over the retaining arm on each hinge. The door should be pulled away at a 30-degree angle. Next, the kick panel can be unscrewed at the corner and removed.
Step three: Connect the electrical wiring according to local codes.
Step four: Connect to the gas line. The gas needs to be shut off. The gas shut-off valve needs to be been previously installed on the stub out. The flexible gas connector needs to be connected in two places: at the shut off valve and at the right rear pipe fitting. It is important not to overtighten the flexible gas connector or use plumbing putty. The cooktop valves and gas supply should be turned off at the shut-off valve. Soap and water can be used to check for gas leaks.
Step five: Level the range to the countertop by measuring and adjusting the leveling legs.
Step six: Slide the oven into the cabinet cutout. The left rear leveling leg engages the anti-tip bracket.
Step seven: Install the burner ring, caps, and porcelain gates. The tabs and corresponding notches need to be aligned.
Step eight: Place on the exhaust cover.
Step nine: Place the grates into their dimples.
Step ten: Reinstall the doors. Slide the doors in at a 30-degree angle. Then, fully open the door and rotate the hinge catches toward the oven.
Step eleven: Remove the protective plastic covering the door panel.
After the appliance has been replaced, there are some things that can be done to avoid appliance repair in the near future. First of all, keeping the range clean is a simple, but smart practice. The top should be wiped down well, especially after spills or boil over. The bar ports on this gas appliance can be unclogged with a straight pin. Metal pins are the best option because plastic or wood can break off inside the ports.
It is very convenient that stoves have a self-cleaning option. In addition to keeping the outside of the stove clean, keeping the inside clean as well helps put off another appliance repair. Remove the racks before doing this because the temperature can reach 850 degrees and they may discolor. Also, crumbs should be swept out before cleaning and leftover ashes should be swept out after cleaning.
Once a year, the door gasket should be inspected. The gasket should be soft and bendable. Hard, brittle gaskets are a red flag. Heat can escape, causing poor performance in these electric appliances. Also, this waste costs energy dollars. If the gasket needs to be replaced, some may jump at the chance for another do it yourself appliance repair. If the gasket is connected with screws, the appliance repair is possible to be done by an amateur. Most of the time, a professional would need to be called in for this type of appliance repair. Those who have installed the appliance themselves, according to the above instructions, have a leg up and should be able to attempt this appliance repair.
Do it yourself appliance repair projects are a great challenge for those who are motivated to push themselves in the home improvement arena. Appliance repair or installation is great practice because it is detailed work. Investing in detailed instruction manuals or videos is a good idea for those who wish to make do it yourself appliance repair projects a regular occurrence.